All CATAGORY
Name: ITX Mini Transparent Case
Chassis style: vertical / horizontal
Material: Acrylic
Color: Transparent
Applicable motherboard: ITX motherboard
Size: As picture
Compatible power supply: DC-ATX power module / PC power supply
Hard disk station: 2×2.5 inch hard drive
High heat dissipation limit: CPU heat sink ≤27mm （Can not install 37mm radiator）
Accessories: Opening *1, HDD LED light *1, screw *1 set,160W DC-ATX power supply
Note: The memory is in front and on the side, the memory will conflict with the light, please be careful!
   The motherboard is not included.
   Please tear off the kraft protective layer when installing
Option
only CASE: Only included the ITX case not Motherboard and DC PSU,please tell me what pattern you like
Pattern(In the figure, in order to see the pattern, the protective film is not peeled off, and the actual color is transparent)：
Installation steps
1. Fix the screws and short copper posts to the screw holes on the main board.
2. Align the screw holes of the main board with the screw holes of the short copper post, and then tighten the screws.
3. Fix the screws and copper posts to the screw holes around the bottom plate of the chassis.
4. Install the power switch on the front panel; install the hard disk on the side panel (the position of the hard disk should be determined according to the space after the motherboard is installed. If the space is sufficient, 2 hard disks can be installed.
Mounted on 2 side panels)
5. Insert the four panels into the slot into the bottom plate.
6. Align the side panel clips, cover the top plate, and finally secure with screws.
