All CATAGORY
Silver T puller + 18 blue weighing 270g, 18 blue spacer weighing 50g
How to use this paintless dent repair kit :.
1. Clean the dent with a clean, damp cloth.
2. Fit the glue stick into the glue gun, pull the trigger to allow the stick to enter the gun and switch on the power to preheat for 5 minutes.
3. Use a suitable stretching spacer. Large dents require a large tension washer. (Note: the larger
tensile washer the greater the pulling force).
4. pull the trigger and apply the drawing shim with extruded glue (the 4 holes of the shim should be coated with hot melt glue).
5. Place the hot melt coated brushed shim quickly in the centre of the dent and press gently until the glue has cured and adhered (allow the glue to cool for approx. 8 minutes. The cooling time should be less than 10 minutes, in winter);
6. aligning the T-patch with the hot melt adhesive, press down on the brushed spacer and pull back on the slide bar to pull up the dent.
7. Check the circuit board. If the dent remains, tap it gently with a flattened hammer or pen.
8. clean the repair with a clean, damp cloth.
=
